Allied Telesis AT-S62 - Manual (Page 204)

Chapter 11: File Downloads and Uploads
204 Section II: Advanced Operations
6. To download a system file using Xmodem, go to Step 7. To download
a file using TFTP, do the following:
a. Type T.
The following prompt is displayed:
TFTP Server IP address:
b. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
c. Enter the name of the file on the TFTP server to download onto the
switch. You can specify only one file.
The following prompt is displayed:
Local File Name:
d. Enter a name for the file for when it is stored in the switch’s file
system. The name can be up to 32 alphanumeric characters.
Spaces are allowed, but special characters (e.g., /, \, #, and %)
should not be used. The extension should match its file type.
Supported extensions and file types are listed in Table 3.
The following message is displayed:
Getting the file from Remote TFTP Server - Please wait
...
e. If you have not already done so, start the TFTP server software.
After downloading the system file, the switch displays the
following message:
File received successfully!
This completes the process for downloading a file using TFTP.
Table 3. File Name Extensions
Extension File Type
.cfg Configuration file
.cer Certificate file
.img AT-S62 image file