Allied Telesis AT-S62 - Manual (Page 57)

AT-S62 Management Software Menus Interface User’s Guide
Section I: Basic Operations 57
Rebooting a Switch
This procedure reboots the switch.
Note
Any configuration changes not save will be lost once the switch
reboots. To save your configuration changes, return to the Main
Menu and type S to select Save Configuration Changes.
To reboot the switch, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration. The
System Administration menu is shown in Figure 4 on page 52.
2. From the System Administration menu, type 9 to select System
Utilities. The System Utilities menu is shown in Figure 6.
Figure 6. System Utilities Menu
3. From the System Utilities menu, type 5 to select Reboot the switch.
The following prompt is displayed:
The switch is about to reboot. Do you want to
proceed? [Yes/No] ->
4. Type Y to reboot the switch or N to cancel the procedure.
Caution
The switch does not forward traffic while it initializes its management
software and reloads the active boot configuration file. This process
can take several minutes to complete. Some packet traffic may be
lost. When the switch is finished rebooting, you can reestablish your
management session if you want to continue managing the unit.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
System Utilities
1 - File Operations
2 - Downloads and Uploads
3 - Ping a remote system
4 - Reset to Factory Defaults
5 - Reboot the switch
6 - Networking Stack
R - Return to Previous Menu
Enter your selection?