Allied Telesis AT-S62 - Manual (Page 535)

AT-S62 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 535
2. Enter the ID number of the MSTI you want to associate a VLAN.
3. A prompt similar to the following is displayed:
Enter the list of VLANs:
4. Enter the VLAN ID of the virtual LAN that you want to associate with
the MSTI. You can enter more than one VLAN at a time (for example,
2,4,7) (To view VIDs, refer to “Displaying VLANs” on page 569.)
The existing VLANs associations are removed from the MSTI when the
new VLANs are added. The removed VLANs are returned to CIST.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Removing All
VLAN
Associations from
an MSTI
To remove all VLAN associations from an MSTI, do the following:
1. From the VLAN-MSTI Association Menu, type 4 to select Clean VLAN
to MSTI Association.
The following prompt is displayed:
Enter the MSTI ID [1 to 15] ->
2. Enter the ID number of the MSTI whose VLAN associations you want
to remove. (You cannot remove VLANs from CIST using this
procedure. To remove a VLAN from CIST, you must assign the VLAN
to an MSTI.)
All VLAN associations are immediately removed from the MSTI and
are returned to CIST.
3. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.