Allied Telesis AT-S62 - Manual (Page 147)

AT-S62 Management Software Menus Interface User’s Guide
Section I: Basic Operations 147
Managing Static Port Trunks
The following procedures explain how to create, modify, and delete static
port trunks:
ˆ “Creating a Static Port Trunk” on page 147
ˆ “Modifying a Static Port Trunk” on page 150
ˆ “Deleting a Static Port Trunk” on page 152
For background information, refer to “Static Port Trunk Overview” on
page 136.
Creating a Static
Port Trunk
This section contains the procedure for creating a static port trunk on a
switch. Be sure to review the guidelines in “Port Trunk Overview” on
page 136 before performing the procedure.
Caution
Do not connect the cables to the trunk ports on the switches until
after you have configured the trunk with the management software.
Connecting the cables before configuring the software will create a
loop in your network topology. Data loops can result in broadcast
storms and poor network performance.
Note
Before creating a port trunk, examine the speed, duplex mode, and
flow control settings of the lowest numbered port that will be a part of
the trunk. Check to be sure that the settings are correct for the end
node to which the trunk will be connected. When you create the
trunk, the AT-S62 management software copies the settings of the
lowest numbered port in the trunk to the other ports so that all the
settings are the same.
You should also check to be sure that the ports are untagged
members of the same VLAN. You cannot create a trunk of ports that
are untagged members of different VLANs.
To create a port trunk, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP.