Allied Telesis AT-S62 - Manual (Page 161)

AT-S62 Management Software Menus Interface User’s Guide
Section I: Basic Operations 161
The LACP (IEEE 8023ad) Configuration menu is shown in Figure 41
on page 155.
4. Type 6 to select Delete Aggregator.
The following prompt is displayed:
Enter Aggregator Name [Max up to 20 alphanumeric
characters]:
5. Enter the name of the aggregator you want to delete. The name is
case-sensitive. You can delete only one aggregator at a time.
A confirmation prompt is displayed.
6. Type Y to delete the aggregator or N to cancel the procedure.
If you entered Yes, the aggregator is deleted.
Displaying LACP
Port or
Aggregator
Status
To display LACP port or aggregator status, perform the following
procedure:
1. From the Main Menu, type 1 to select Port Configuration.
2. From the Port Configuration menu, type 4 to select Port Trunking and
LACP.
The Port Trunking and LACP menu is shown in Figure 38 on page 148.
3. Type 2 to select LACP Configuration.
The LACP (IEEE 8023ad) Configuration menu is shown in Figure 41
on page 155.
4. To view port status, type 7 to select Show LACP Port Status. To view
aggregator status, type 8 to select Show LACP Aggregator Status.