Allied Telesis AT-S62 - Manual (Page 593)

AT-S62 Management Software Menus Interface User’s Guide
Section V: VLANs 593
Enabling or Disabling GVRP on a Port
This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.
Note
To protect against unauthorized access to restricted areas of your
network, Allied Telesyn recommends disabling GVRP on unused
ports and those ports that are connected to GVRP-inactive devices.
For further information, refer to “GVRP and Network Security” on
page 585.
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 188 on page 559.
2. From the VLAN Configuration menu, type 8 to select Configure GARP-
GVRP.
The GARP-GVRP menu is shown in Figure 200 on page 591.
3. Type P - GVRP Port Parameters to configure the switch ports.
The GVRP Port Parameters Menu is shown in Figure 201.
Figure 201. GVRP Port Parameters Menu
4. Type 1 to configure GVRP Port Settings.
The following prompt is displayed:
Enter port-list:
5. Enter a port. You can configure more than one port at a time.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2006
GVRP Port Parameters
1 - Configure GVRP Port Settings
2 - Display GVRP Port Configuration
R - Return to Previous Menu
Enter your selection?