Test security, Setting up remaining functions, Of the powermonitor 5000 unit – Rockwell Automation Energy Management Accelerator Toolkit Quick Start User Manual
Page 77
Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
77
Energy Data Collector Configuration Chapter 3
Only one admin type account is permitted to be active at a time.
Now that the network administrator user has been created, you can continue setting up the PowerMonitor 5000 unit by
connecting through the native EtherNet/IP port and using the network Web interface. This includes the ability to
configure additional users, administrators, and application security accounts.
Test Security
To test the network administrator login, follow these steps.
1.
Browse to the network address of
the PowerMonitor 5000 unit.
2.
Click Log in from the page
header and enter the user name
and password just created and
click Log In.
Note that only the USB Web interface
can be used to enable, disable, or reset
security. If security accounts are lost or
forgotten, you will need to connect to
the USB Web interface and log in with
the usbadmin account to create new
network security accounts.
Setting Up Remaining Functions of the PowerMonitor 5000 Unit
The remaining functions are set up in the same way as the examples discussed in this section. For additional details on
configuring the PowerMonitor 5000 unit refer to the PowerMonitor 5000 Unit user manual, publicat
.
Optionally, the PowerMonitor 5000 device can be configured using the FactoryTalk EnergyMetrix software. Refer to the
FactoryTalk EnergyMetrix software user manual, publication
r details.