Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 126)

126 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 6 FactoryTalk EnergyMetrix Software Device Setup
Configure a PowerMonitor Device
Follow these steps to configure a PowerMonitor device.
1. Select the Devices folder on the
System tab.
2. Navigate to and select the
appropriate group or domain.
In this example, select the Electricity
group under the Engineering
subdomain.
3. Click the Add a device link.
4. Choose a subdomain or group from
the Parent group list.
For this example, choose Electricity.
5. Check the boxes as shown.
The checkboxes vary by device type.
If the device will not be connected
during configuration, clear the Enable
device checkbox to avoid timeout
errors.
6. Choose a device from the Device class
list.
For this example, choose
PowerMonitor 1000 (EM3) on
EtherNet/IP.
7. Enter a name for the device.
For this example, enter Boiler House.
8. Enter the Time zone and Time sync
interval.
Devices with internal clocks may be time-synched, such as power monitors and controllers.
9. Enter the communication path to the
device.
For this example the communication
path to the first PowerMonitor 1000
EM3 device is AB_ETH-1\10.10.10.1.
10. Modify other communication settings
as needed.
For details, refer to the FactoryTalk EnergyMetrix software help.
Device password applies only to the power monitors.
The default of zero matches the default power monitor
password