Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 268)

268 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 11 FactoryTalk View ME Energy Faceplates
In this example, the Overload, Phase Loss, and Comm Fault trips are enabled.
Configure RSLogix5000 for the E3 Plus Faceplate
Follow these procedures to configure the faceplate.
Add the 193-DNENCAT(R) Communication Module to your Ethernet Network
1. Create a new or open an existing RSLogix 5000 file.
2. Under I/O Configuration, right-click the network communication module to be used for the intended E3 Plus
module.
3. Select ‘New Module’.
IMPORTANT This step assumes you have already added and configured an Ethernet module to your I/O tree.