beautypg.com

Rockwell Automation Energy Management Accelerator Toolkit Quick Start User Manual

Page 75

background image

Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014

75

Energy Data Collector Configuration Chapter 3

EXAMPLE

This example explains how to change from a DHCP-assigned to a static IP address.

The initial network configuration is shown below. The IP address assigned is 192.168.200.8. The network administrator has pro-
vided a range of static IP addresses in the same subnet, beginning with 192.168.200.100. In this case, the default gateway and
DNS servers remain the same for static or DHCP-obtained addresses (verify if this is true in your case with your network adminis-
trator).

To change to the new address, from the IP_Address_Obtain pull-down menu choose Static, type in the new IP address, and click
Apply Changes.

IMPORTANT

You can change the network configuration from the USB or network web pages. If you change the IP address from the network
Web interface, you will then need to browse to the new IP address to re-establish communication.