Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 280)

280 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 11 FactoryTalk View ME Energy Faceplates
Configure ME E300 Faceplate
The ME E300 Faceplate files provide a preconfigured display and associated logic for the E300 Electronic Overload Relay
using FactoryTalk View Machine Edition and RSLogix5000 software. The faceplate includes status, control, diagnostic,
and energy views controlled by its own toolbar buttons.
The E300 module faceplate is compatible only with E300 Relay modules communicating over the EtherNet/IP network.
Shows status and provides operator control of the Trip Reset and Outputs.
Shows the last fault.
Shows a trend of the current or %TCU.
Home Display Fault Display
Configuration Display
Energy Display
Trend Display
Lets you configure the min and max EU values to be
displayed on the trend display and rename the device
for display at the top of the faceplate
The energy data displayed is dependent on the
module definition configured in the controller. If
you do not have a voltage-sensing module
configured, only the current is displayed on the
energy tab.