Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 45)

Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014 45
System Configuration and Wiring Chapter 2
3. Review meter names.
The meter names are autopopulated in the worksheet based on energy data point names.
4. Choose Electric as the Meter Type for all the PowerMonitor devices.
5. Select or enter meter tag names for each data point based on the Energy Type and Meter Type shown in the table.
Energy Type Meter Type Meter Tag Names
Electricity
Electric
Real Energy Net
Reactive Energy Net
Reactive Power Demand
PM Status Input
Real Energy Net (1)
(1) If there is only one energy data point of a particular energy type then select the meter tag name listed in the
table. If there is more than one energy data point with the same energy type then select a blank meter name
and type [EnergyDataPointName] [EnergyType] Usage, for example, Boiler House Natural Gas Usage.
L2x Input
OPC
Natural Gas PM Status Input
Natural Gas Usage (1) L2x Input
OPC
Fuel Oil PM Status Input
Fuel Oil Usage (1) L2x Input
OPC
Propane PM Status Input
Propane Usage (1) L2x Input
OPC
Steam PM Status Input
Propane Usage (1) L2x Input
OPC
Air PM Status Input
Air Usage (1) L2x Input
OPC
Water PM Status Input
Water Usage (1) L2x Input
OPC