Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 417)

Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014 417
Time of Day Control Chapter 13
Reset Command To reset all schedule entries for the day to the default, click Reset Day to Default. The default
value is 99:99. When a value of 99:99 is entered, the setting is ignored by the TOD program.
Days of the Week Click on a day of the week to configure the schedule for that day. The TOD schedule for the day
highlighted in green is displayed in the configuration view.
Holiday Enable/
Disable
When holidays are enabled, the load will follow its holiday schedule whenever a holiday is
configured on the calendar. To modify the holiday schedule, click on the ‘HOL’ day of the week
button. When holidays are disabled, the holiday schedule for the load is ignored. Click on the
Holidays Enabled/Disabled button to toggle between holidays enabled or disabled.
Time of Day
Schedule
By default, all schedule entries are set to 99:99. If a value of 99:99 is entered, the setting is
ignored by the TOD program.
Click on the Start Time or Stop Time Hour or Minute to launch the keypad input object and enter
a time. Enter start and stop times in military time, 00:00 through 23:59.
Once the desired schedule for the day is entered, Click Save Day Changes to download the
schedule to the controller.
Tip: To run the load overnight, configure a start time, but leave the stop time at 99:99. On the next
day, configure a start time of 00:00. For example the load configured below would start at 20:00
on Monday and stop at 6:00 on Tuesday.
Time and Date The current time and date are displayed in the lower right corner of the faceplate.
Button Icons Description