Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 389)

Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014 389
Demand Control Chapter 12
Demand Controller Tags
When the DemandControl program is imported, three User Defined Data Types will be added to the controller;
DemandFaceplate, Load, and PM.
The DemandFaceplate UDT is used for the HMI interface.
Name Data Type Description
Set_FaceplateAnimation INT Controls the visibility on the faceplate
Set_LoadNum DINT Load number currently being configured
Set_Password STRING Password entered from the HMI
Cfg_Load Load Configured Load Buffer
Cfg_Password STRING Configured Password
Cfg_StartHour DINT Configured Demand Control Start Hour
Cfg_StartMin DINT Configured Demand Control Start Minute
Cfg_StopHour DINT Configured Demand Control Stop Hour
Cfg_StopMin DINT Configured Demand Control Stop Minute
Cfg_PeakDays BOOL[32] Configured Peak Days of the week
Cmd_PasswordEntered DINT Set when a password is entered from the
faceplate (Bit 0 is set when a password is
entered for demand control configuration, bits
1…16 are set when a password is entered for
configuring a specific load)
Cmd_SetPriority BOOL Set when a new priority is entered from the load
configuration screen
Cmd_SetKWRated BOOL Set when a new KW rating is entered from the
load configuration screen
Cmd_SetDesc BOOL Set when a new load description is entered from
the load configuration screen
Cmd_SetOnDelay BOOL Set when a new on delay time is entered from
the load configuration screen
Cmd_SetOffDelay BOOL Set when a new off delay time is entered from
the load configuration screen
Cmd_SetMaxOffTime BOOL Set when a new maximum off time is entered
from the load configuration screen
Sts_PasswordAccepted BOOL Set when the correct password is entered from
the faceplate, allowing visibility of the
configuration screen
Sts_BillingKW DINT Used for color animation of the present billing
kW
Sts_PredKW DINT Used for color animation of the predicted kW
demand
Val_ActiveAlarm DINT Used for displaying the highest priority alarm on
the faceplate
Val_AlmLabel STRING Used for displaying the load name on the
faceplate when the load shed failed alarm is
active