Configure the ethernet ip, Address – Rockwell Automation Energy Management Accelerator Toolkit Quick Start User Manual
Page 58
58
Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 3 Energy Data Collector Configuration
Configure the Ethernet IP Address
Follow these steps to configure the Ethernet IP address of the PowerMonitor 3000 module.
The default IP address is 192.168.254.
xxx, where xxx is the unit’s id.
1.
Press the Down Arrow key to select PROG mode.
2.
Press the Enter key to access Edit mode.
You should see PASS.? and four flashing zeroes, 0000, on the display.
3.
Press the Up and Down arrow keys to select the four-digit password and press the Enter key.
The default password is 0000.
4.
Press the Down arrow key to select CONFIGURATION, then press the Enter key.
5.
Press the Down Arrow key until you see OPTIONAL COMM, then press the Enter key.
You should see IP ADDR. BYTE 1 on the display.
The syntax of the IP address is four bytes connected by decimal points: aaa.bbb.ccc.ddd. Each byte has a value in the
range 0…255.
6.
Press the Enter key to access the parameter value for editing.
7.
Press the Up Arrow or Down Arrow key to select the desired value.
8.
Press the Enter key to write the new value to the PowerMonitor 3000 master module.
9.
Press the Down Arrow key to select the next IP address byte.
10.
Repeat steps 6…9 to edit the remaining IP address byte values.
11.
Repeat steps 6…10 to configure the Subnet Mask and Gateway IP addresses as required.
12.
Press the Escape key twice to return to the Configuration menu.
TIP
Before starting the procedure, make sure the PowerMonitor 3000 display module is connected to the PowerMonitor
3000 device and control power is on.
TIP
You can press and hold the Up Arrow or Down Arrow key for a few seconds to increase the rate the value increments or
decrements.
TIP
When editing a parameter, the phase indicators at the right of the display module are solid and the
parameter flashes. After pressing the Enter key to store the new value, the phase indicators flash and the
parameter turns solid.