Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 170)

170 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 8 FactoryTalk EnergyMetrix Software Alarm Setup
Configure Email Alarm Subscriptions
You can configure one or more email subscriptions for an alarm. A subscription supports three email addresses and a
schedule that determines when each email address is active. Alarm subscriptions are assigned to a specific domain or all
domains.
Follow these steps to set up an email subscription for an alarm.
1. Select My User Settings on the System
tab, then click the Edit.
2. Check Enable alarm notifications, then
click Save.
3. Click the Add a new alarm subscription
link.
4. Select the group or domain to which you
want to subscribe.
To subscribe to all domains, select the
default of All.
5. Enter up to three email
addresses.
6. Click the Add new notification
period link to set up each alarm
notification period.
• Select a day or day range
from the pull-down list.
• Enter start and end times for
each period.
To set up a notification period
of all day, leave all times at zero.
For this example, a weekday notification was set for email address #1, and a weekend notification was set for email
address #2.
7. Click Save.
IMPORTANT For emails to be sent on alarm, you must also:
– Check Send email on trigger or Send email on clear from the Add Alarm page when configuring alarm.
– Configure an SMTP server by selecting Configuration on the System tab. Refer to page 171 .