Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 294)

294 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 11 FactoryTalk View ME Energy Faceplates
7. Select the firmware of the device you are using.
8. Enter the DataLink Module Definitions exactly as shown.
9. Click OK to accept the changes.
10. Click OK again to close the dialog box.
11. In the Data Types folder, verify these module-defined data types have been created.
IMPORTANT If the firmware revision of your drive is not listed, refer to the lower left corner of the Module Definition window for instructions on
how to create a database.
IMPORTANT The datalinks listed must be configured exactly as shown for successful faceplate AOI import and operation. If additional datalinks
are required for your application, modifications to the corresponding AOIs may be required. Refer to step 4 of the Set Other SMC-50
Parameters section, for more information on how to modify the AOI.