Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 306)

306 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 11 FactoryTalk View ME Energy Faceplates
Configure ME CIP Motion Drive Faceplates
The ‘ME CIP Motion Energy Faceplate’ files let you quickly load, configure, and use a preconfigured status display or
‘faceplate’ for the CIP Motion Servo Drives by using FactoryTalk View Machine Edition software.
System Compatibility
The faceplate and routine import files are compatible with the following software:
• Studio 5000 Logix Designer application, version 21.00 or later
• FactoryTalk View Machine Edition software, version 7.0 or later
The faceplate files are also compatible with the following faceplates:
• Equipment Status Faceplate Rev 1.0
• Alarm History Faceplate Rev 1.0
General Setup
After downloading your faceplate zip file, the following folders are created:
• ME_CIPMotion_Energy_Faceplate_Files - contains the CIP Motion Energy faceplate, parameter file, and
controller logic
• ME_CIPMotion_Goto Buttons - contains the image used in creating a Goto button for your HMI display
IMPORTANT This faceplate covers Kinetix® K6500, K5500, and K350 drives. The instructions show the Kinetix K5500 drive as an example. These
instructions are similar for the other drives.
IMPORTANT These instructions are for CIP Motion Servo Drives (Kinetix 350, 5500, and 6500) communicating over an EtherNet/IP network.