Enterasys Networks D-Series - Manual (Page 97)

Enterasys D-Series CLI Reference 5-1
5
Discovery Protocol Configuration
This chapter describes how to configure discovery protocols.
Configuring CDP
Purpose
To review and configure the Enterasys CDP discovery protocol. This protocol is used to discover
network topology. When enabled, this protocol allows Enterasys devices to send periodic PDUs
about themselves to neighboring devices.
Commands
The commands used to review and configure the CDP discovery protocol are listed below.
For information about... Refer to page...
Configuring CDP 5-1
Configuring Cisco Discovery Protocol 5-7
Configuring Link Layer Discovery Protocol and LLDP-MED 5-13
For information about... Refer to page...
show cdp 5-2
set cdp state 5-3
set cdp auth 5-4
set cdp interval 5-4
set cdp hold-time 5-5
clear cdp 5-5
show neighbors 5-6