Enterasys Networks D-Series - Manual (Page 120)

set lldp port status
5-24 Discovery Protocol Configuration
Example
This example sets the number of fast start LLDPDUs to be sent to 4.
D2(rw)->set lldp med-fast-repeat 4
set lldp port status
Use this command to enable or disable transmitting and processing received LLDPDUs on a port
or range of ports.
Syntax
set lldp port status {tx-enable | rx-enable | both | disable} port-string
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables both transmitting LLDPDUs and receiving and processing LLDPDUs from
remote systems on ports
ge .1.1 through ge .1.6.
D2(rw)->set lldp port status both ge.1.1-6
set lldp port trap
Use this command to enable or disable sending LLDP notifications (traps) when a remote system
change is detected.
Syntax
set lldp port trap {enable | disable} port-string
Parameters
tx‐enable Enables transmitting LLDPDUs on the specified ports.
rx‐enable Enables receiving and processing LLDPDUs from remote systems on
the specified ports.
both Enables both transmitting and processing received LLDPDUs on the
specified ports.
disable Disables both transmitting and processing received LLDPDUs on the
specified ports.
port‐string Specifies the port or range of ports to be affected.
enable Enable transmitting LLDP traps on the specified ports.
disable Disable transmitting LLDP traps on the specified ports.
port‐string Specifies the port or range of ports to be affected.