Enterasys Networks D-Series - Manual (Page 342)

set cos port-resource
11-26 Policy Classification Configuration
Defaults
None.
Mode
Switch command, read‐write.
Usage
The default port group 0.0 cannot be deleted.
Example
This example deletes all Port Groups except for the Default group 0.0:
D2(su)->clear cos port-config irl all
set cos port-resource
Use this command to set the inbound rate limit parameters for a specific IRL resource for a specific
port group.
Syntax
set cos port-resource irl group-type-index irl-index {[unit {kbps}] [rate rate]
[type {drop}]}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
irl Set an IRL port resource.
group‐type‐index Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
irl‐index Index number of the inbound rate limiter resource associated with this
entry. Valid values range from 0 to 99.
unit Unit of measure for the inbound rate limiter (only option is Kbps).
kbps Kilobits per second.
rate rate Data rate for this inbound rate limiter. This is the actual rate limit. Valid
values range from 512 to 1,000,000 Kbps for a Gigabit port.
type drop Action for the rate limiter. The only action option is drop the frame if all
limiters are exceeded.