Enterasys Networks D-Series - Manual (Page 411)

Statistics Group Commands
Enterasys D-Series CLI Reference 15-3
Statistics Group Commands
Purpose
To display, configure, and clear RMON statistics.
Commands
show rmon stats
Use this command to display RMON statistics measured for one or more ports.
Syntax
show rmon stats [port-string]
Parameters
Defaults
If port‐string is not specified, RMON stats will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON statistics for Gigabit Ethernet port 1 in switch 1.
: D2(su)->show rmon stats ge.1.1
Port: ge.1.1
-------------------------------------
Index = 1
Owner = monitor
Data Source = ifIndex.1
Drop Events = 0 Packets = 0
Collisions = 0 Octets = 0
Jabbers = 0 0 - 64 Octets = 0
Broadcast Pkts = 0 65 - 127 Octets = 0
Note: Due to hardware limitations, the only frame error counted is oversized frames.
For information about... Refer to page...
show rmon stats 15-3
set rmon stats 15-4
clear rmon stats 15-4
port‐string (Optional) Displays RMON statistics for specific port(s).