Enterasys Networks D-Series - Manual (Page 165)

show lacp
Enterasys D-Series CLI Reference 6-39
show lacp
Use this command to display information about one or more aggregator ports.
Syntax
show lacp [port-string]
Parameters
Defaults
If port‐string is not specified, link aggregation information for all LAGs will be displayed.
Mode
Switch command, read‐only.
Usage
Each D‐Series module provides 6 virtual link aggregator ports, which are designated in the CLI as
lag.0.1 through lag.0.6. Once underlying physical ports (that is, fe.x.x) are associated with an
aggregator port, the resulting aggregation will be represented as one Link Aggregation Group
(LAG) with a lag.x.x port designation.
Example
This example shows how to display lacp information for lag.0.1 . The following table describes the
output fields.
D2(su)->show lacp lag.0.1
Global Link Aggregation state: enabled
Single Port LAGs: disabled
Aggregator: lag.0.1
Actor Partner
System Identifier: 00:01:F4:5F:1E:20 00:11:88:11:74:F9
System Priority: 32768 32768
Admin Key: 32768
Oper Key: 32768 0
Attached Ports: ge.1.1
ge.1.3
Table 6‐11 provides an explanation of the command output.
clear lacp singleportlag 6-43
show port lacp 6-45
set port lacp 6-46
clear port lacp 6-48
For information about... Refer to page...
port‐string (Optional) Displays LACP information for specific LAG port(s). Valid
port designations are lag.0.1 ‐ 6.