Enterasys Networks D-Series - Manual (Page 113)

show lldp port location-info
Enterasys D-Series CLI Reference 5-17
Parameters
Defaults
If port‐string is not specified, TLV configuration information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display transmit TLV information for three ports.
D2(ro)->show lldp port tx-tlv ge.1.1-3
* Means TLV is supported and enabled on this port
o Means TLV is supported on this port
Means TLV is not supported on this port
Column Pro Id uses letter notation for enable: s-stp, l-lacp, g-gvrp
Ports Port Sys Sys Sys Mgmt Vlan Pro MAC PoE Link Max MED MED MED MED
Desc Name Desc Cap Addr Id Id PHY Aggr Frame Cap Pol Loc PoE
------- ---- ---- ---- --- ---- ---- ---- --- --- ---- ---- --- --- --- ---
ge.1.1 * * * * * * slg * * * * *
ge.1.2 * * * * * * slg * * *
ge.1.3 * * * * * * slg * * * * *
show lldp port location-info
Use this command to display configured location information for one or more ports.
Syntax
show lldp port location-info [port-string]
Parameters
Defaults
If port‐string is not specified, port location configuration information will be displayed for all
ports.
Mode
Switch command, read‐only.
Example
This example shows how to display port location information for three ports.
D2(ro)->show lldp port location-info ge.1.1-3
port‐string (Optional) Displays information about TLV configuration for one or a
range of ports.
port‐string (Optional) Displays port location information for one or a range of
ports.