Enterasys Networks D-Series - Manual (Page 213)

show snmp notifyfilter
Enterasys D-Series CLI Reference 7-33
Example
This example shows how to clear the SNMP notify configuration for “hello”:
D2(su)->clear snmp notify hello
show snmp notifyfilter
Use this command to display SNMP notify filter information, identifying which profiles will not
receive SNMP notifications.
Syntax
show snmp notifyfilter [profile] [subtree oid-or-mibobject] [volatile |
nonvolatile | read-only]
Parameters
Defaults
If no parameters are specified, all notify filter information will be displayed.
Mode
Switch command, read‐only.
Usage
See “ About SNMP Notify Filters ” on page 7‐28 for more information about notify filters.
Example
This example shows how to display SNMP notify filter information. In this case, the notify profile
“pilot1” in subtree 1.3.6 will not receive SNMP notification messages:
D2(su)->show snmp notifyfilter
--- SNMP notifyFilter information ---
Profile = pilot1
Subtree = 1.3.6
Filter type = included
Storage type = nonVolatile
Row status = active
profile (Optional) Displays a specific notify filter.
subtree oid‐or‐
mibobject (Optional) Displays a notify filter within a specific subtree.
volatile |
nonvolatile | read‐
only (Optional) Displays notify filter entries of a specific storage type.