Enterasys Networks D-Series - Manual (Page 83)

Resetting the Switch
Enterasys D-Series CLI Reference 2-45
Mode
Switch command, read‐only.
Usage
By default, switch timeout occurs after 15 minutes of user inactivity, automatically closing your
CLI session. Use the
set logout command ( page 2‐27 ) to change this default.
Example
This example shows how to exit a CLI session:
D2(su)->exit
Resetting the Switch
Purpose
To reset one or more switches, and to clear the user‐defined configuration parameters.
Commands
reset
Use this command to reset the switch without losing any user‐defined configuration settings.
Syntax
reset
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to reset the system:
D2(su)->reset
This command will reset all modules and may disconnect your telnet session.
For information about... Refer to page...
reset 2-45
clear config 2-46