Enterasys Networks D-Series - Manual (Page 476)

set dot1x
17-14 Security Configuration
Port : 1 Auth-Config
PAE state: Initialize
Backend auth state: Initialize
Admin controlled directions: Both
Oper controlled directions: Both
Auth controlled port status: Authorized
Auth controlled port control: Auto
Quiet period: 60
Transmission period: 30
Supplicant timeout: 30
Server timeout: 30
Maximum requests: 2
Reauthentication period: 3600
Reauthentication control: Disabled
set dot1x
Use this command to enable or disable 802.1X authentication, to reauthenticate one or more access
entities, or to reinitialize one or more supplicants.
Syntax
set dot1x {enable | disable | port {init | reauth} {true | false} [port-string]}
Parameters
Defaults
If no ports are specified, the reinitialization or reauthentication setting will be applied to all ports.
Mode
Switch command, read‐write.
Usage
Disabling 802.1X authentication globally, by not entering a specific port‐string value, will enable
the EAP pass‐through feature. EAP pass‐through allows client authentication packets to be
forwarded unmodified through the switch to an upstream device.
Examples
This example shows how to enable 802.1X:
D2(su)->set dot1x enable
This example shows how to reinitialize ge .1.2:
D2(rw)->set dot1x port init true ge.1.2
enable | disable Enables or disables 802.1X.
port Enable or disable 802.1X reauthentication or initialization control on one or
more ports.
init | reauth Configure initialization or reauthentication control.
true | false Enable (true) or disable (false) reinitialization/reauthentication.
port‐string (Optional) Specifies the port(s) to reinitialize or reauthenticate.