Enterasys Networks D-Series - Manual (Page 261)

clear spantree lp
Enterasys D-Series CLI Reference 8-43
Defaults
If no port‐string is specified, status is displayed for all ports.
If no SID is specified, SID 0 is assumed.
Mode
Switch command, read‐only.
Example
This example shows how to display Loop Protect status on fe.2.3:
D2(su)->show spantree lp port fe .2.3
LoopProtect is disabled on port fe .2.3 , SI
clear spantree lp
Use this command to return the Loop Protect status per port and optionally, per SID, to its default
state of disabled.
Syntax
clear spantree lp port-string [sid sid]
Parameters
Defaults
If no SID is specified, SID 0 is assumed.
Mode
Switch command, read‐write.
Example
This example shows how to return the Loop Protect state on fe.2.3 to disabled:
D2(rw)->clear spantree lp port fe .2.3
show spantree lplock
Use this command to display the Loop Protect lock status per port and/or per SID. A port can
become locked if a configured number of Loop Protect events occur during the configured
window of time. See the
set spantree lpthreshold and set spantree lpwindow commands. Once a
port is forced into blocking (locked), it remains locked until manually unlocked with the clear
spantree lplock command.
Syntax
show spantree lplock [port port-string] [sid sid]
port‐string Specifies port(s) for which to clear the Loop Protect feature status.
sid sid (Optional) Specifies the specific Spanning Tree(s) for which to clear the
Loop Protect feature status. Valid values are 0 ‐ 4094. If not specified,
SID 0 is assumed.