Commands, Show port priority, Set port priority – Enterasys Networks D-Series User Manual
Page 350: Commands -2, Show port priority -2 set port priority -2
show port priority
12-2
Port Priority and Rate Limiting Configuration
•
Display the current traffic class mapping‐to‐priority of each port.
•
Set each port to transmit frames according to 802.1D (802.1p) priority set in the frame header.
Commands
show port priority
Use this command to display the 802.1D priority for one or more ports.
Syntax
show port priority [port-string]
Parameters
Defaults
If port-string is not specified, priority for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the port priority for the fe.2.1 through 5.
D2(su)->show port priority
fe
.2.1-5
fe
.2.1 is set to 0
fe
.2.2 is set to 0
fe
.2.3 is set to 0
fe
.2.4 is set to 0
fe
.2.5 is set to 0
set port priority
Use this command to set the 802.1D (802.1p) Class‐of‐Service transmit priority (0 through 7) on
each port. A port receiving a frame without priority information in its tag header is assigned a
priority according to the priority setting on the port. For example, if the priority of a port is set to
5, the frames received through that port without a priority indicated in their tag header are
classified as a priority 5.
A frame with priority information in its tag header is transmitted according to that priority.
For information about...
Refer to page...
show port priority
set port priority
clear port priority
port‐string
(Optional) Displays priority information for a specific port. For a detailed
description of possible port‐string values, refer to “