Show pwa, Show pwa -63, Show pwa output details -63 – Enterasys Networks D-Series User Manual
Page 525
show pwa
Enterasys D-Series CLI Reference
17-63
show pwa
Use this command to display port web authentication information for one or more ports.
Syntax
show pwa [port-string]
Parameters
Defaults
If port‐string is not specified, PWA information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display PWA information for
ge
.2.1:
D2(su)->show pwa ge.2.1
PWA Status - enabled
PWA IP Address - 192.168.62.99
PWA Protocol - PAP
PWA Enhanced Mode - N/A
PWA Logo - enabled
PWA Guest Networking Status - disabled
PWA Guest Name - guest
PWA Redirect Time - N/A
Port Mode AuthStatus QuietPeriod MaxReq
-------- ---------------- -------------- ----------- ---------
ge.2.1
disabled
disconnected 60 16
provides an explanation of the command output.
show pwa session
set pwa enhancedmode
For information about...
Refer to page...
port‐string
(Optional) Displays PWA information for specific port(s).
Table 17-49
show pwa Output Details
Output Field
What It Displays...
PWA Status
Whether or not port web authentication is enabled or disabled. Default state of
disabled can be changed using the set pwa command as described in “
PWA IP Address
IP address of the end station from which PWA will prevent network access until the
user is authenticated. Set using the set pwa ipaddress command as described in
“
PWA Protocol
Whether PWA protocol is CHAP or PAP. Default setting of PAP can be changed
using the set pwa protocol command as described in “