Enterasys Networks D-Series - Manual (Page 248)

set spantree spanguardtrapenable
8-30 Spanning Tree Configuration
set spantree spanguardtrapenable
Use this command to enable or disable the sending of an SNMP trap message when SpanGuard
has locked a port.
Syntax
set spantree spanguardtrapenable {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable the SpanGuard trap function:
D2(su)->set spantree spanguardtrapenable disable
clear spantree spanguardtrapenable
Use this command to reset the Spanning Tree SpanGuard trap function back to the default state of
enabled.
Syntax
clear spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the SpanGuard trap function to enabled:
D2(rw)->clear spantree spanguardtrapenable
disable | enable Disables or enables sending SpanGuard traps. By default, sending traps
is enabled.