Enterasys Networks D-Series - Manual (Page 202)

clear snmp view
7-22 SNMP Configuration
clear snmp view
Use this command to delete an SNMPv3 MIB view.
Syntax
clear snmp view viewname subtree
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to delete SNMP MIB view “public”:
D2(su)->clear snmp view public 1.3.6.1
Configuring SNMP Target Parameters
Purpose
To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command (“
set snmp targetaddr ” on page 7‐26).
Commands
show snmp targetparams
Use this command to display SNMP parameters used to generate a message to a target.
Syntax
show snmp targetparams [targetParams] [volatile | nonvolatile | read-only]
viewname Specifies the MIB view name to be deleted.
subtree Specifies the subtree name of the MIB view to be deleted.
For information about... Refer to page...
show snmp targetparams 7-22
set snmp targetparams 7-24
clear snmp targetparams 7-24