Enterasys Networks D-Series - Manual (Page 40)

Setting User Accounts and Passwords
2-2 Basic Configuration
Setting User Accounts and Passwords
Purpose
To change the switch’s default user login and password settings, and to add new user accounts
and passwords.
Commands
Table 2-2 Optional CLI Setup Commands
Task CLI commands
Refer to
page...
Save the active configuration. save config 2-36
Enable or disable SSH. set ssh enable | disable 17-74
Enable or disable Telnet. set telnet {enable | disable} [inbound |
outbound | all]
2-33
Enable or disable HTTP
management (WebView). set webview {enable | disable} 2-48
Enable or disable SNMP port link
traps. set port trap port-string {enable | disable} 6-22
Set the per port broadcast limit set port broadcast port-string threshold-value 6-31
Configure a VLAN. set vlan create vlan-id 9-5
set port vlan port-string vlan-id modify-egress 9-9
Set a Syslog server IP and
severity set logging server index ip-addr ip-addr
severity severity state enable
9-9
Configure and enable a RADIUS
server. set radius server index ip-addr
port [secret-value]{realm {management-access |
any | network-access}
17-5
set radius enable 17-5
Configure and enable first arrival
MAC locking on user ports. set maclock firstarrival port-string value 17-59
set maclock enable port-string 17-54
For information about... Refer to page...
show system login 2-3
set system login 2-4
clear system login 2-4
set password 2-5
set system password length 2-6
set system password aging 2-6
set system password history 2-7
show system lockout 2-7
set system lockout 2-8