Enterasys Networks D-Series - Manual (Page 114)

show lldp port local-info
5-18 Discovery Protocol Configuration
Ports Type Location
-------- ------------- -------------------------
ge.1.1 ELIN 1234567890
ge.1.2 ELIN 1234567890
ge.1.3 ELIN 1234567890
show lldp port local-info
Use this command to display the local system information stored for one or more ports. You can
use this information to detect misconfigurations or incompatibilities between the local port and
the attached endpoint device (remote port).
Syntax
show lldp port local-info [port-string]
Parameters
Defaults
If port‐string is not specified, local system information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display the local system information stored for port fe.4.1. Table 5‐4
describes the output fields of this command.
D2(rw)->show lldp port local-info fe .4.1
Local Port : fe .4.1 Local Port Id: fe .4.1
--------------------
Port Desc : ... 1000BASE-TX RJ45 Gigabit Ethernet Frontpanel Port
Mgmt Addr : 10.21.64.100
Chassis ID : 00-E0-63-93-74-A5
Sys Name : LLDP PoE test Chassis
Sys Desc : Enterasys Networks, Inc.
Sys Cap Supported/Enabled : bridge,router/bridge
Auto-Neg Supported/Enabled : yes/yes
Auto-Neg Advertised : 10BASE-T, 10BASE-TFD,
100BASE-TX, 100BASE-TXFD,
1000BASE-TFD,
Bpause
Operational Speed/Duplex/Type : 100 full tx
Max Frame Size (bytes) : 1522
Vlan Id : 1
LAG Supported/Enabled/Id : no/no/0
Protocol Id : Spanning Tree v-3 (IEEE802.1s)
LACP v-1
GVRP
port‐string (Optional) Displays local system information for one or a range of
ports.