Enterasys Networks D-Series - Manual (Page 322)

Configuring Classification Rules
11-6 Policy Classification Configuration
Configuring Classification Rules
Purpose
To review, create, assign, and unassign classification rules to policy profiles. This maps user
profiles to protocol‐based frame filtering policies.
Commands
show policy rule
Use this command to display policy classification rule information.
Syntax
show policy rule [all | admin-profile | profile-index] [ether | icmptype | ipproto
| ipdestsocket | ipsourcesocket | iptos | macdest | macsource | tcpdestport |
tcpsourceport | udpdestport | udpsourceport] [data] [mask mask] [port-string port-
string] [rule-status {active | not-in-service | not-ready}] [storage-type {non-
volatile | volatile}] [vlan vlan] | [drop | forward] [dynamic-pid dynamic-pid]
[cos cos] [admin-pid admin-pid] [-verbose] [usage-list] [display-if-used]
Parameters
Note: B3, C3, and G3 devices support profile-based CoS traffic rate limiting only. Policy rules
specifying CoS will not rate limit on these devices, or on mixed stacks including B3 or C3 devices.
For information about... Refer to page...
show policy rule 11-6
show policy capability 11-8
set policy rule 11-10
clear policy rule 11-12
clear policy all-rules 11-14
all | admin‐
profile | profile‐
index Displays policy classification rules for all profiles, profile ID 0 (admin‐
profile), or for a specific profile index number. Valid values are 1 ‐ 1023.
ether Displays Ethernet type II rules.
icmptype Displays ICMP type rules.
ipproto Displays IP protocol field in IP packet rules.
ipdestsocket Displays IP destination address rules.
ipsourcesocket Displays IP source address rules.
iptos Displays Type of Service rules.
macdest Displays MAC destination address rules.
macsource Displays MAC source address rules.