Enterasys Networks D-Series - Manual (Page 249)

show spantree legacypathcost
Enterasys D-Series CLI Reference 8-31
show spantree legacypathcost
Use this command to display the default Spanning Tree path cost setting.
Syntax
show spantree legacypathcost
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the default Spanning Tree path cost setting.
D2(su)->show spantree legacypathcost
Legacy Path Cost is disabled.
set spantree legacypathcost
Use this command to enable or disable legacy (802.1D) path cost values.
Syntax
set spantree legacypathcost {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Usage
By default, legacy path cost is disabled. Enabling the device to calculate legacy path costs affects
the range of valid values that can be entered in the set spantree adminpathcost command.
Example
This example shows how to set the default path cost values to 802.1D.
D2(rw)->set spantree legacypathcost enable
disable Use 802.1t2001 values to calculate path cost.
enable Use 802.1d1998 values to calculate path cost.