Enterasys Networks D-Series User Manual
Page 173
set port lacp
Enterasys D-Series CLI Reference
6-47
Defaults
At least one parameter must be entered per port‐string.
If enable or disable are not specified, port(s) will be enabled with the LACP parameters entered.
Mode
Switch command, read‐write.
aadminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync
| lacpcollect |
lacpdist | lacpdef |
lacpexpire
Sets the port’s actor LACP administrative state to allow for:
lacpactive ‐ Transmitting LACP PDUs.
lacptimeout ‐ Transmitting LACP PDUs every 1 sec. vs 30 sec. (default).
lacpagg ‐ Aggregation on this port.
lacpsync ‐ Transition to synchronization state.
lacpcollect ‐ Transition to collection state.
lacpdist ‐ Transition to distribution state.
lacpdef ‐ Transition to defaulted state.
lacpexpire ‐ Transition to expired state.
aportpri aportpri
Sets the port’s actor port priority. Valid values are 0 ‐ 65535, with lower
values designating higher priority.
asyspri asyspri
Sets the port’s actor system priority. The LACP implementation on the D‐
Series device uses this value to determine aggregation precedence when
there are two devices competing for the same aggregator. Valid values are
0 ‐ 65535, with higher precedence given to lower values.
Note: Only one LACP system priority can be set on a D-Series
device, using either this command, or the set lacp asyspri command
(“
enable
(Optional) Enables LACPDU processing on this port.
disable
(Optional) Disables LACPDU processing on this port.
padminkey
padminkey
Sets a default value to use as the port’s partner admin key. Only ports with
matching admin keys are allowed to aggregate. Valid values are 1 ‐ 65535.
padminport
padminport
Sets a default value to use as the port’s partner admin value. Valid values
are 1 ‐ 65535.
padminportpri
padminportpri
Sets a default value to use as the port’s partner port priority. Valid values
are 0 ‐ 65535, with lower values given higher priority.
padminstate
lacpactive |
lacptimeout |
lacpagg | lacpsync
| lacpcollect |
lacpdist | lacpdef |
lacpexpire
Sets a port’s partner LACP administrative state. See aadminstate for valid
options.
padminsysid
padminsysid
Sets a default value to use as the port’s partner system ID. This is a MAC
address.
padminsyspri
padminsyspri
Sets a default value to use as the port’s partner priority. Valid values are 0
‐ 65535, with lower values given higher priority.