Enterasys Networks D-Series - Manual (Page 152)

set linkflap interval
6-26 Port Configuration
Mode
Switch command, read‐write.
Example
This example shows how to enable the link trap monitoring on all ports.
D2(rw)->set linkflap portstate enable
set linkflap interval
Use this command to set the time interval (in seconds) for accumulating link down transitions.
Syntax
set linkflap interval port-string interval-value
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the link flap interval on port fe.1.4 to 1000 seconds.
D2(rw)->set linkflap interval fe .1.4 1000
set linkflap action
Use this command to set reactions to a link flap violation.
Syntax
set linkflap action port-string {disableInterface | gensyslogentry | gentrap |
all}
Parameters
port‐string Specifies the port(s) on which to set the link flap interval.
interval‐value Specifies an interval in seconds. A value of 0 will set the interval to
forever.
port‐string Specifies the port(s) on which to set the link flap action.
disableInterface Sets the reaction as disabling the interface.
gensyslogentry Sets the reaction as generating a syslog entry.
gentrap Sets the reaction as generating an SNMP trap.
all Sets the reaction as all of the above.