Enterasys Networks D-Series - Manual (Page 243)

show spantree spanguard
Enterasys D-Series CLI Reference 8-25
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the protocol state migration machine on port 20:
D2(su)->set spantree protomigration ge.1.20
show spantree spanguard
Use this command to display the status of the Spanning Tree SpanGuard function.
Syntax
show spantree spanguard
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the SpanGuard function status:
D2(su)->show spantree spanguard
Spanguard is disabled
set spantree spanguard
Use this command to enable or disable the Spanning Tree SpanGuard function.
Syntax
set spantree spanguard {enable | disable}
Parameters
Defaults
None.
enable | disable Enables or disables the SpanGuard function.