Enterasys Networks D-Series - Manual (Page 49)

clear ip address
Enterasys D-Series CLI Reference 2-11
Mode
Switch command, read‐write.
Usage
Paramters must be entered in the order shown (host IP, then mask, then gateway) for the
command to be accepted.
Example
This example shows how to set the system IP address to 10.1.10.1 with a mask of 255.255.128.0:
D2(su)->set ip address 10.1.10.1 mask 255.255.128.0
clear ip address
Use this command to clear the system IP address.
Syntax
clear ip address
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the system IP address:
D2(rw)->clear ip address
show ip protocol
Use this command to display the method used to acquire a network IP address for switch
management.
Syntax
show ip protocol
Parameters
None.
Defaults
None.