Show port lacp, Show port lacp -45 – Enterasys Networks D-Series User Manual
Page 171
show port lacp
Enterasys D-Series CLI Reference
6-45
Example
This example shows how to reset the single port LAG function back to disabled:
D2(su)->clear lacp singleportlag
show port lacp
Use this command to display link aggregation information for one or more underlying physical
ports.
Syntax
show port lacp port port-string {[status {detail | summary}] | [counters]}
Parameters
Defaults
None.
Mode
Switch command, read‐only.
Usage
State definitions, such as ActorAdminState and Partner AdminState, are indicated with letter
abbreviations. If the show port lacp command displays one or more of the following letters, it
means the state is true for the associated actor or partner ports:
•
E = Expired
•
F = Defaulted
•
D = Distributing (tx enabled)
•
C = Collecting (rx enabled)
•
S = Synchronized (actor and partner agree)
•
G = Aggregation allowed
•
S/l = Short/Long LACP timeout
•
A/p = Active/Passive LACP
For more information about these states, refer to set port lacp (
) and the IEEE 802.3 2002
specification.
Examples
This example shows how to display detailed LACP status information
f
or port fe.1.12:
D2(su)-> show port lacp port
fe
.1.12 status detail
port port‐string
Displays LACP information for specific port(s). For a detailed description
of possible port‐string values, refer to “
Port String Syntax Used in the CLI
status detail |
summary
Displays LACP status in detailed or summary information.
counters
Displays LACP counter information.