Enterasys Networks D-Series - Manual (Page 437)

show dhcp conflict
Enterasys D-Series CLI Reference 16-5
Example
This example enables DHCP conflict logging.
D2(rw)->set dhcp conflict logging
show dhcp conflict
Use this command to display conflict information, for one address or all addresses.
Syntax
show dhcp conflict [address]
Parameters
Defaults
If no address is specified, conflict information for all addresses is displayed.
Mode
Read‐only.
Example
This example displays conflict information for all addresses. Note that ping is the only detection
method used.
D2(ro)->show dhcp conflict
IP address Detection Method Detection Time
----------- ----------------- ---------------
192.0.0.2 Ping 0 days 19h:01m:23s
192.0.0.3 Ping 0 days 19h:00m:46s
192.0.0.4 Ping 0 days 19h:01m:25s
192.0.0.12 Ping 0 days 19h:01m:26s
clear dhcp conflict
Use this command to clear conflict information for one or all addresses, or to disable conflict
logging.
Syntax
clear dhcp conflict {logging | ip-address| *}
Parameters
address [Optional] Specifies the address for which to display conflict information.
logging Disables conflict logging.
ip‐address Clears the conflict information for the specified IP address.
* Clears the conflict information for all IP addresses.