Show spantree output details -6, Example – Enterasys Networks D-Series User Manual
Page 224
show spantree stats
8-6
Spanning Tree Configuration
Example
This example shows how to display the device’s Spanning Tree configuration:
D2(su)->show spantree stats
Spanning tree status - enabled
Spanning tree instance - 0
Designated Root MacAddr - 00-e0-63-9d-c1-c8
Designated Root Priority - 0
Designated Root Cost - 10000
Designated Root Port - lag.0.1
Root Max Age - 20 sec
Root Hello Time - 2 sec
Root Forward Delay - 15 sec
Bridge ID MAC Address - 00-01-f4-da-5e-3d
Bridge ID Priority - 32768
Bridge Max Age - 20 sec
Bridge Hello Time - 2 sec
Bridge Forward Delay - 15 sec
Topology Change Count - 7
Time Since Top Change - 00 days 03:19:15
Max Hops - 20
shows a detailed explanation of command output.
Table 8-23
show spantree Output Details
Output
What It Displays...
Spanning tree instance
Spanning Tree ID.
Spanning tree status
Whether Spanning Tree is enabled or disabled.
Designated Root MacAddr
MAC address of the designated Spanning Tree root bridge.
Designated Root Port
Port through which the root bridge can be reached.
Designated Root Priority
Priority of the designated root bridge.
Designated Root Cost
Total path cost to reach the root.
Root Max Age
Amount of time (in seconds) a BPDU packet should be considered valid.
Root Hello Time
Interval (in seconds) at which the root device sends BPDU (Bridge Protocol
Data Unit) packets.
Root Forward Delay
Amount of time (in seconds) the root device spends in listening or learning
mode.
Bridge ID MAC Address
Unique bridge MAC address, recognized by all bridges in the network.
Bridge ID Priority
Bridge priority, which is a default value, or is assigned using the set
spantree priority command. For details, refer to “
Bridge Max Age
Maximum time (in seconds) the bridge can wait without receiving a
configuration message (bridge “hello”) before attempting to reconfigure.
This is a default value, or is assigned using the set spantree maxage
command. For details, refer to “
Bridge Hello Time
Amount of time (in seconds) the bridge sends BPDUs. This is a default
value, or is assigned using the set spantree hello command. For details,
refer to “