Enterasys Networks D-Series - Manual (Page 142)

set port negotiation
6-16 Port Configuration
Example
This example shows how to display auto‐negotiation status for 1‐Gigabit Ethernet port 14 in slot 3:
D2(su)->show port negotiation ge.3.14
auto-negotiation is enabled on port ge.3.14.
set port negotiation
Use this command to enable or disable auto‐negotiation on one or more ports.
Syntax
set port negotiation port-string {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable auto‐negotiation on 1‐Gigabit Ethernet port 3 in slot 14:
D2(su)->set port negotiation ge.3.14 disable
show port advertise
Use this command to display port capability and advertisement as far as speed and duplex for
auto‐negotiation.
Syntax
show port advertise [port-string]
Parameters
Defaults
If port‐string is not specified, advertisement for all ports will be displayed.
Mode
Switch command, read‐only.
port‐string Specifies the port(s) for which to enable or disable auto‐negotiation. For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.
enable | disable Enables or disables auto‐negotiation.
port‐string (Optional) Displays advertised ability for specific port(s). For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.