Enterasys Networks D-Series - Manual (Page 71)

set telnet
Enterasys D-Series CLI Reference 2-33
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display Telnet status:
D2(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
set telnet
Use this command to enable or disable Telnet on the switch.
Syntax
set telnet {enable | disable} [inbound | outbound | all]
Parameters
Defaults
If not specified, both inbound and outbound Telnet service will be enabled.
Mode
Switch command, read‐write.
Example
This example shows how to disable inbound and outbound Telnet services:
D2(su)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
telnet
Use this command to start a Telnet connection to a remote host. The D‐Series switch allows a total
of four inbound and / or outbound Telnet session to run simultaneously.
Syntax
telnet host [port]
enable | disable Enables or disables Telnet services.
inbound |
outbound | all (Optional) Specifies inbound service (the ability to Telnet to this switch),
outbound service (the ability to Telnet to other devices), or all (both
inbound and outbound).