Enterasys Networks D-Series - Manual (Page 215)

show snmp notifyprofile
Enterasys D-Series CLI Reference 7-35
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to delete the SNMP notify filter “pilot1”:
D2(su)->clear snmp notifyfilter pilot1 subtree 1.3.6
show snmp notifyprofile
Use this command to display SNMP notify profile information. This associates target parameters
to an SNMP notify filter to determine who should not receive SNMP notifications.
Syntax
show snmp notifyprofile [profile] [targetparam targetparam] [volatile |
nonvolatile | read-only]
Parameters
Defaults
If no parameters are specified, all notify profile information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display SNMP notify information for the profile named “area51”:
D2(su)->show snmp notifyprofile area51
--- SNMP notifyProfile information ---
Notify Profile = area51
TargetParam = v3ExampleParams
Storage type = nonVolatile
profile Specifies an SNMP filter notify name to delete.
subtree oid‐or‐
mibobject Specifies a MIB subtree ID containing the filter to be deleted.
profile (Optional) Displays a specific notify profile.
targetparam
targetparam (Optional) Displays entries for a specific target parameter.
volatile |
nonvolatile | read‐
only (Optional) Displays notify filter entries of a specific storage type.