Enterasys Networks D-Series - Manual (Page 451)

set dhcp pool bootfile
Enterasys D-Series CLI Reference 16-19
set dhcp pool bootfile
Use this command to specify a default boot image for the DHCP clients who will be served by the
address pool being configured.
Syntax
set dhcp pool poolname bootfile filename
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example sets the boot image filename for address pool named “auto1.”
D2(rw)->set dhcp pool auto1 bootfile image1.img
clear dhcp pool bootfile
Use this command to remove a default boot image from the address pool being configured.
Syntax
clear dhcp pool poolname bootfile
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the boot image filename from address pool named “auto1.”
D2(rw)->clear dhcp pool auto1 bootfile
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.
filename Specifies the boot image file name.
poolname Specifies the name of the address pool. Pool names may be up to 31
characters in length.