Enterasys Networks D-Series - Manual (Page 339)

set cos port-config
Enterasys D-Series CLI Reference 11-23
Parameters
Defaults
If not specified, all CoS entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to show all CoS settings:
D2(su)->show cos settings
CoS Index Priority ToS IRL
--------- ---------- ------- -----
0 0 * *
1 1 * *
2 2 * *
3 3 * *
4 4 * *
5 5 * *
6 6 * *
7 7 * *
set cos port-config
Use this command to create a port group for inbound rate limiting and add or remove ports from
the group.
Syntax
set cos port-config irl group-type-index [name name] [ports port-list] [append] |
[clear]
Parameters
cos‐list (Optional) Specifies a Class of Service entry to display.
irl Specifies that this is an inbound rate limiting (IRL) port group.
group‐type‐index Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port‐type.
Valid values for group# can range from 0 to 7. Valid values for port‐type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0.
name name (Optional) User defined name for the group.
ports port‐list (Optional) Ports assigned to the group. All ports must be of the same port
type (Fast Ethernet, Gigabit Ethernet).
append (Optional) Append (add) the ports to the ports that are already in the
group.
clear (Optional) Clear the given ports from those assigned to the group.