Enterasys Networks D-Series - Manual (Page 379)

set logging application
Enterasys D-Series CLI Reference 14-7
Mode
Switch command, read‐only.
Example
This example shows how to display system logging information pertaining to the SNMP
application.
D2(ro)->show logging application SNMP
Application Current Severity Level
---------------------------------------------
90 SNMP 6
1(emergencies) 2(alerts) 3(critical)
4(errors) 5(warnings) 6(notifications)
7(information) 8(debugging)
Table 14‐33 provides an explanation of the command output.
set logging application
Use this command to set the severity level of log messages for one or all applications.
Syntax
set logging application {[mnemonic | all]} [level level]
Parameters
Table 14-33 show logging application Output Details
Output Field What it displays...
Application A mnemonic abbreviation of the textual description for
applications being logged.
Current Severity Level Severity level at which the server is logging messages for the
listed application. This range (from 1 to 8) and its associated
severity list is shown in the CLI output. For a description of these
entries, which are set using the set logging application
command, refer to “
set logging application ” on page 14-7.
mnemonic pecifies a case sensitive mnemonic abbreviation of an application to be
logged. This parameter will vary depending on the number and types of
applications running on your system. To display a complete list, use the
show logging application command as described in “
show logging
application ” on page 14‐6. Sample mnemonics and their corresponding
applications are listed in Table 14‐34 on page 14‐8.
Note: Mnemonic values are case sensitive and must be typed as they appear in
Table 14-34.
all Sets the logging severity level for all applications.