Enterasys Networks D-Series - Manual (Page 310)

set diffserv policy police style simple
10-12 Differentiated Services Configuration
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to mark packets matching the “admin” policy in the “system” class for
DSCP expedited forwarding precedence:
D2(rw)->set diffserv policy mark ipdscp admin system ef
set diffserv policy police style simple
Use this command to establish the policing style for a Diffserv policy based only on bandwidth for
the specified class.
Syntax
set diffserv policy police style simple policyname classname bandwidth burstsize
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to configure a bandwidth‐based policing style for the “admin” Diffserv
policy:
D2(rw)->set diffserv policy police style simple admin system 1000 128
ipdscp |
ipprecedence Specifies that packets will be marked with either an IP DSCP or precedence
value.
policyname Specifies the policy name being configured.
classname Specifies a Diffserv class to associate to this policy.
value Specifies an IP DSCP or precedence value. Valid numeric or keyword DCSP
values can be entered as listed in
Section 10‐27 . Valid precedence values are:
0 ‐ 7.
policyname Specifies the policy name being configured.
classname Specifies a Diffserv class to associate to this policy.
bandwidth Specifies a bandwidth value in Kbps. Valid values are 1 ‐ 4294967295.
burstsize Specifies a burst size value im Kbytes. Valid values are 1 ‐ 128.